Comeup Industrial Winch (Ver:03) Manuel d'utilisateur télécharger pdf (Page 3)

I . Safety Requirement

In some cases, the operator of a winch may be required to have

qualifications according to applicable laws and ordinances.

Check safety and environmental conditions prior to and

during use.

Only use correctly rated wire rope in construction, strength.

Inspect for damage and/or defects before use.

Don’t use an unsuitable hook and snatch block for rope.

The operator must remain with the winch during operation.

The winch duty rating is S3 (intermittent-periodic).

Do not use the winch as a lifting device or a hoist for vertical lifting and moving people

Ensure that the winch is connected to the correct power source such as hydraulic or12/24V DC.

Do not exceed maximum line pull ratings. Shock load must not exceed these ratings.

Keep hands clear of wire rope and roller fairlead opening.

Pull from an angle below 3° in the horizontal plane to straighten

up the vehicle or load.

Always use leather gloves when handling the wire rope.

When winching, always use a recovery damper. Place over

the wire rope in the middle third of its length.

A wire rope should be replaced if it shows signs of excessive

wear, broken strands, corrosion or any other defects.

If the winch fails to pull a load under normal conditions, stop

the operation within 30 seconds, or motor damage may occur.

Check that the clutch T-handle is in the “Engaged” position during and after use.

Remove the remote control from the winch when not in use.

Do not wrap the wire rope around the load and back onto itself. Always use a tree truck strap.

Keep hands and clothes away from the winch, wire rope, and roller fairlead.

Never unplug the remote control when winching a load.

To avoid insufficient power when winching a load, the vehicle should be running and in neutral.

If noise or vibration occurs when running, stop

the winch immediately and return it for repair.

The rope shall be wound in according to drum

rotation sticker or refer to owners manual.

！

General Rules

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Comeup Industrial Winch (Ver:03) Manuel d'utilisateur Page 3